How To Use A Laser Cutter? And What Are CNC Laser Cutting Machine Operating Rules?

When the CNC laser pipe cutter is working, it is very dangerous if it breaks down. Novices must be trained by professionals to operate independently. Golden Laser experts of the CNC laser pipe cutter machine have summarized 13 safe work details of the CNC tube laser machines based on their experience. The details are as follows:

Comply With Laser Cutting Machine Operation And Management Regulation

• Comply with the safety operation rules of general CNC fiber laser tube cutting machines. Start the laser cutting operation strictly according to the laser start-up procedure.

• Operators of CNC tube laser machines must be trained, familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.
  

• The operation of the CNC tube laser cutters must wear labor protective equipment as required and must wear protective glasses that meet the regulations near the laser beam.

• When the CNC tube laser cutter machine is started, the operator shall not leave the post without authorization or trust someone to be in charge. If it is really necessary to leave, the operator should stop or cut off the power switch.

• When there is a CNC laser tube cutter abnormality in the processing process, it should be stopped immediately. It is suggested to remove the fault in time or report it to the supervisor.

• The laser, the bed and the surrounding site of the CNC laser tube cutter machine clean should be kept clean, orderly, and free of oil pollution. The workpieces, plates, and wastes are stacked according to regulations.

• High-voltage safety regulations must be followed when the CNC tube laser cutter is maintained. Follow regulations and procedures that every 40-hour operation or weekly maintenance. Every1000-hour operation or every six-month maintenance should strictly comply.

Sate Using Regulations On Laser Cutting Machine Operation Process

• The CNC fiber laser tube cutting machine should not process material before you make it clear whether this material can be irradiated or heated by a laser, so as to avoid potential dangers such as smoke and vapor.

• Put the fire extinguisher within easy reach. Turn off the laser or shutter when the CNC laser tube cutter is not processing. Do not place papers, cloth, or other flammable objects near the unprotected laser beam.

• When the CNC tube cutting laser machine uses gas cylinders, it is necessary to avoid crushing the welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder monitoring regulations. Do not expose cylinders to sunlight or near heat sources. When opening the bottle valve, the operator must stand on the side of the bottle's mouth.

• After the CNC laser cutter for tube is turned on, the machine tool should be manually started in the X and Y directions at low speed to check whether there is any abnormality.
  

• After the CNC laser tube cutting machine enters a new workpiece program, it should first run it for trial operation and check its operation.
  

• When the CNC tube laser cutting equipment is working, pay attention to observing the operation of the machine tool, so as to prevent the cutting machine from going out of the effective stroke range or the collision of two machines causing an accident.